One way to maintain also the nicest look of our hardwood flooring is to make necessary repairs. Although we are extremely careful in our floors, there are always accidents like water spilling and burns that may happen to our floors. We can maintain the shining status of our floor by merely following those things that were mentioned here. Burns can be removed by using sand paper to scratch off the burned area and then a damp cloth to remove the grit. Once the wood is dry, we can apply a putty or wood putty to cover or patch the area and then let it dry. After drying, we can refinish it to look shiny again.
The first thing that always get noticed when people visit a home, is the floor. In this matter, it is vital for us to maintain a clean and shiny hardwood floor. Many households refinish their hardwood floor because by doing so, you can make the wood more shiny and clean. If we see any damage, it must also be immediately repaired to maintain its superb condition. We must also put absorbent cloth or rugs near the areas where water is always present, just like near the toilet or kitchen sink. We must follow these pieces of advice if we want to maintain a clean and shiny looking hardwood floor.
Our Recommended Vacuum cleaner for Hardwood Floor
The new vacuum cleaners for hardwood floors like Bissell Flip-It Bare Floor Cleaner make sweeping old school. You can simply put this machine into ‘dry’ mode and vacuum the dirt up off your floors. This comes in really handy if you have grout work or crevices that make sweeping not so effective. When you have all the dirt vacuumed up you can set the Bissell into ‘wet’ mode. Press the trigger to dispense the water and start scrubbing the floor. The Bissell Flip-It Bare Floor Cleaner is much lighter than some of the Hoover models, but it has small tanks as a result. This means that if you have a lot of floor to clean you may have to refill the tanks to get the job done. Lighter also means less back pain though.
Now it’s time for the really neat part. Since you are scrubbing away on your floor, instead of letting that dirty water just dry there, vacuum it up. Pull the Bissell backwards and suck up all that dirty water. This allows you to get your floors much cleaner than conventional means and also means less buildup to cause sticky floors. Another added bonus is that since you are sucking up most of the water your floors dry faster. If you want the floors that you could eat off of, try using this vacuum cleaner for hardwood floor and you are sure to get the results you want.
